Conventional MCP electronic module, with 2nd micro-switch

804951

Approval: VdS

Same as 804950, but with second microswitch with dry contact NC/C (break) or NO/C (make) that is activated when the alarm is triggered.
  • Slimline design
  • Low power consumption
  • Plug-in connection terminals (two direction)
  • Optional terminal terminals
  • Triple key function (test, open, reset)
  • Detectors that are not ready for operation can be marked with the "Out of order" label by reversing the enclosed glass pane

Additional Information:
If the glass pane is replaced with the optionally available plastic pane with reset function, the MCP can be reset from the outside using the key. For the surface mounting of the MCP the surface mount base Part No. 704980 must be ordered separately, if the cable wasn't laid about a standard flush mount wall socket. Type a definition - single action in accordance with EN 54-11 § 3.4.1 (excerpt taken from EN standard): Manual fire alarm unit, for which the alarm status is automatically set (additional alarm triggering is not required) after the fragile element has been broken or its position has been changed.
Alarm displayLED, red and yellow flag
Alarm current @ 9 V DCtyp. 9 mA
Connection terminalmax. 2,5 mm² (AWG 26-14)
Application temperature-20 °C ... 70 °C
Operating voltage8 ... 30 V DC
Weight gapprox. 78 g
Contact load30 V DC/1 A
Storage temperature-30 °C ... 75 °C
No. of detector/zonemax. 10 detectors per loop (as per VdS)
Air humidity< 95 % (non-condensing)
Quiescent current @ 9 V DCapprox. 0 μA
Type of protectionIP 43 (in housing), IP 55 with cover 704965
VdS-NrG 205131
DimensionsW: 88 mm H: 88 mm D: 57 mm (with surface mount housing)